ARM Electronics IP540_620MDVANVP - Manual (Page 62)

62
6. Network Environments
It is required to follow the recommendation of the environments where IP540/IP620MDVAIVP will be
installed or the similar environments.
6-1. Private line Environment
Usually Company, University, Research center uses the leased line. They use many public IP addresses. In
order to install IP540/IP620MDVAIVP under this environment, select “Static IP Address” in ‘ Static IP Setting ’
of ‘ 3. Basic setting ’ and input IP address, subnet mask and gateway. If there is DHCP server on the network,
select ‘Dynamic IP Address’ in ‘ Dynamic IP ’ of ‘ 3. Basic Setting ’. You can get all the information (IP address,
subnet mask, gateway, DHCP server) from the network administrator. Sometimes, the
IP540/IP620MDVAIVP may not work properly if the user installed firewall for security purpose. In this case,
open the port on the IP540/IP620MDVAIVP, then it will work properly. You can check the current port of
IP540/IP620MDVAIVP from the “Administrator's Page”->”Network Setting”->”Port Setting” (see ‘ 3. Basic
Setting ‘). The default port is set on ex-factory as follows :
¾ Web Connection Port: Port 80 TCP
¾ Authentication and Control Port: Port 9000 TCP
¾ Video Streaming Port: Port 9001 TCP
¾ 1 way Audio Port: Port 9002 TCP
¾ 2 way Audio Port : Port 9003 TCP
6-2. Broadband (ADSL, Cable, Fiber Optic) Modem Environment
Home, store, small office use one Broadband modem (DSL, Cable Modem), and use one public IP
address normally. In order to use several PC through one Public IP address, the user in most cases use IP
sharing device. We recommend using an IP router (IP Sharing device) to install the IP540/IP620MDVAIVP.
There may be a case in no need of router, but most people use IP540/IP620MDVAIVP and other PC 1set
or more. When using the router, connect the router and input IP address of IP540/IP620MDVAIVP (IP
address of IP540/IP620MDVAIVP is set as 192.168.1.8 on ex-factory) in DMZ menu. If the user cannot
use the DMZ function because there is no DMZ menu in the router or some other reasons, go into port
forwarding or NAT menu on the router and map the port of IP540/IP620MDVAIVP one by one. User can
check the current port setting of IP540/IP620MDVAIVP from “Administrator's Page”->”Network Setting”-
>”Port Setting” (see ‘ 3. Basic Setting ‘). Manufacturer’s setting of IP540/IP620MDVAIVP is as follow on ex-
factory : (The user can change port if necessary).
¾ Web Connection Port : Port 80 TCP
¾ Authentication and Control Port : Port 9000 TCP
¾ Video Streaming Port : Port 9001 TCP
¾ 1 way Audio Port : Port 9002 TCP
¾ 2 way Audio Port : Port 9003 TCP