Yamaha YSP-1100 - Manual (Page 82)

ADJUSTING SYSTEM PARAMETERS
Setting the TURN ON VOLUME
You can set the initial volume level when the power of this
unit is turned on.
1
Repeat steps 1 to 3 in “Using the system
parameters” on page 76.
2
Set the operation mode selector to YSP to
switch to the operation mode of this unit.
TV/AV
vsF n
Press STANDBY/ON on the front panel to set
this unit to the standby mode.
The new setting for the maximum volume level will
be activated when you turn on the power of this unit
next time.
Setting the DEMO MODE
You can test the beam output from this unit to experience
the sound beam.
Press on the remote control so that
TURN ON VOLUME is shown in the front
panel display.
'URH OH OOLUflE
=
4
Press ENTER.
You can also perform this function simply by pressing INPUT on
the front panel. A sound beam is output from this unit when you
press and hold INPUT for more than 2 seconds. The sound beam
shuttles between left and right twice, and then stops.
1
Repeat steps 1 to 3 in “Using the system
parameters” on page 76.
2
Set the operation mode selector to YSP to
switch to the operation mode of this unit.
yvml
i\l
Press ^ ^ on the remote control so that
DEMO MODE is shown in the front panel
display.
5
Press <| / D to adjust the initial volume level.
Control range: MAX, 99 to 01, OFF
Control step: 1
DEMO MODE
76
En