Using auto setup (inlelllbeam), Assembling the supplied cardboard microphone stand, Using auto setup (intellibeam) – Yamaha YSP-1100 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUTO SETUP (IntelliBeam)
Using AUTO SETUP (InlelllBeam)
Once the optimizer microphone is firmly connected to this
unit and properly placed in your listening room, follow the
procedure below to start the AUTO SETUP procedure.
You can also enter the AUTO SETUP procedure simply by
pressing and holding AUTO SETUP on the remote control
more than 2 seconds. In this case, this unit performs both
of the beam optimization and sound optimization
procedures.
■ Assembling the supplied cardboard
microphone stand
You will find three separate parts (one circular-shaped part
and two longitudinal-shaped parts) of the cardboard
microphone stand originally put together.
oTo
1
Disassemble the three parts of the cardboard
microphone stand originally put together.
STANDSY’ON POWER POWFR
'■tм/м)'. O -fwl'
ÌNPUT1 (NPUT2 MACRO
iS D D
■ IWraODE SLEEP
a □ a a
semi»
STi^ggA)« 3BEAM
4
Insert one of the longitudinal-shaped part
into the crevice of the other longitudinal-
shaped part.
Place the circular-shaped part on top of the
two combined longitudinal-shaped parts.
Place the supplied optimizer microphone on
top of the circular-shaped part.
31
En