Yamaha YSP-1100 - Manual (Page 44)

PLAYBACK
Set the operation mode selector to YSP to switch
to the operation mode of this unit and then press
VCR on the remote control to play back a video
tape.
IV/AV
Y$P
n
Playlag back sources
Once an input source is selected (see page 39), you can
play back the selected input source.
Note
This section uses a DVD player as an example of the playback
source.
Set the operation mode selector to YSP to switch
to the operation mode of this unit and then press
AUX on the remote control to play back a
component connected to the AUX jack on the
rear panel of this unit.
For details on the TV and the DVD player you are using, refer to
the owner’s manual supplied with the TV and the DVD player.
1
Turn on the power of your DVD player using
the remote control supplied with the DVD
player.
2
Switch to the video input on your TV using
the remote control supplied with the TV so
that the DVD menu screen is displayed.
3
If necessary, turn down the volume of your
TV until you cannot hear any sound.
4
Set the operation mode selector to YSP to
switch to the operation mode of this unit.
TVMV. n
Press DVD on the remote control to select
DVD as the input source.
5
Play back the DVD on your DVD player using
the supplied remote control.
Audio signals from your DVD player are output from
this unit.
•
• You can check the digital signal being input at the DVD player
with the digital connection (optical/coaxial). Press ST+3BEAM
on the remote control while playing back a DVD recorded in 5.1
channel. The □□ DIGITAL or M m indicator lights up when
this unit detects the 5.1 channel signal input at the optical/
coaxial jack. If the PCM indicator lights up, confirm the digital
connection and the settings of the digital output, bitstream
output, and/or DTS output of the DVD player.
' If the output volume is too low, increase the volume on this unit
to around 45.
• If you have set the appropriate remote control codes for your
TV and DVD player, you can use the remote control supplied
with this unit to operate these components. For details on how
to set remote control codes, see page 81.
40 £n