Notes, 3 press menu on the remote control, S e ii – Yamaha YSP-1100 User Manual

Page 36: Fill seiuf

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

AUTO SETUP (IntelliBeam)

Notes

• Make sure that your listening room is as quiet as possible while

this unit is performing the AUTO SETUP procedure.

• To achieve the best results possible, evacuate yourself from

your listening room until the AUTO SETUP procedure is
completed so that you may not obstruct the path of sound
beams.

• Be advised that it is normal for loud test tones to be output

during the AUTO SETUP procedure.

• The AUTO SETUP procedure may not be run successfully if

this unit is installed in one of the rooms described in “Before
installing this unit” on page 11. In such cases, run MANUAL
SETUP (see page 60) to manually adjust the corresponding
parameters.

• If an error occurs, an error buzzer is played, the AUTO SETUP

procedure stops and then an error message appears on the
screen. See “Error messages for AUTO SETUP” on page 35 for
appropriate remedies.

• The AUTO SETUP procedure takes about 3 minutes maximum.

A chime is played when the AUTO SETUP procedure is run
successfully.

• If there are curtains in your listening room, we recommend

following the procedure below.

1. Open the curtains to improve sound reflection.

2. Run BEAM OPTIMZ only.
3. Close the curtains.
4. Run SOUND OPTIMZ only.

• You can save the settings optimized by the AUTO SETUP

procedure (see page 36). A set of settings optimized according
to specific conditions of your listening environment can be
recalled later depending on the varying conditions of your
listening environment (see page 37).

Press STANDBY/ON on the front panel or on

the remote control to turn on the power of
this unit.
If a subwoofer is connected to this unit, turn on the
power of the subwoofer.

Press MENU on the remote control.

The SET MENU screen appears on your TV.

S E II

> MEMORV

■flUTO SETUP

•MflHUfiL SETUP

•LANGUAGE SETUP

Cjt]/[T]:Up/Dowri

[ENTER]: Enter-

• The control buttons used for SET MENU are displayed on

the bottom of the screen.

• To return to the previous screen while using SET MENU,

press RETURN on the remote control.

• To cancel the SET MENU screen, press MENU again.
• You can start the BEAM+SOUND OPTIMZ procedure

simply by pressing and holding AUTO SETUP on the
remote control for more than 2 seconds. Step 4 and 5 are
skipped and then the screen shown in step 5 is displayed
on your TV. Start the AUTO SETUP procedure from

step 6.

• You can also perform the following operations in the front

panel display.

Press ^ ^ on the remote control to select
AUTO SETUP and then press ENTER.

The following screen appears on your TV.

Front panel

Remote control

Set the operation mode selector to YSP to
switch to the operation mode of this unit.

■fill SEIUF

■ 1>BEAM+SOUND OPTIMZ

2) BEAM OPTIMZ only

3) SOUND OPTIMZ only

[jt]/[T]:Up/Down

[ENTER]: Enter-

TV/AV _