Hudson Robotics SOLO User Manual
Page 45
45
3.12 – GetLevel Step
The GetLevel step allows the user to detect and record, in a file, the liquid level
inside selected wells in a microplate located at one of the SOLO’s six plate nests.
The user begins by selecting the plate nest (and its type of plate) where the
microplate being measured will be located. Next, using the “Browse…” button
depicted in this step’s display (below), the user selects the location and name of
the file where the liquid level data will be saved.
The user should also select the “Search Speeds” (as percents of full speed) at
which the probe tip will descend to the liquid surface, and the speed at which the
syringe piston will expel air until the surface is reached. The user must then