Hudson Robotics SOLO User Manual

Page 35

3.3 – Dispense Step

This step will move the pipettor to a selected dispense position, then dispense the

indicated volume of fluid. The display shown below depicts a Dispense step

expelling 95 uL into well ‘C2’ of a 384-well plate located at Position1 on the

SOLO’s deck on its first execution, then 75 uL into well ‘C6’ on its second

execution:

The parameter selections are identical to those of the Aspirate step, except for the

following:

Mixing – Same as Aspirate step, except in opposite order, but ends with a

dispense as well.

Blow-off – This amount will be expelled from the syringe after the last

‘dispense’ amount in this step is released. It is used to blow off a

droplets that may be on the tip at the end of dispensing.