5 setting an image to training mode – IEI Integration ITDB-100L User Manual

Page 71

ITDB-100L Barcode Reader

Page 62

6.5.5 Setting an Image to Training Mode

The user can set a scanned barcode as a sample image so that the barcode reader

decodes only the same barcode type and size.

Follow the steps below to set a barcode

image to training mode by using the Android app.

NOTE:

The training mode function can also be enabled by using the PC setup

tool or the trigger and tuning control button. Refer to Section 5.6.2 for

details.

Step 1:

Tap

to start the training mode function.

Step 2:

Four beeps are being generated, the illumination LEDs start to flash and the

training mode button turns to

, indicating that the training mode timer is

started.

Step 3:

The user has to tap

to trigger the ITDB-100L within twelve

seconds after the timer is started.

Step 4:

When successfully set a barcode as a sample image, two beeps should be

generated and the training mode button turns to

If the barcode training is failed, four beeps will be generated.

Step 5:

To disable the training mode, tap