IEI Integration ITDB-100L - Manual (Page 31)

ITDB-100L Barcode Reader
Page 22
3.3.2 Ethernet Connector
The ITDB-100L is equipped with an Ethernet connector that allows connection to a
computer/network hub. Follow the steps below to connect the ITDB-100L to a
computer/network hub by using the supplied Ethernet cable.
Step 1: Locate the Ethernet connector . The location of the Ethernet connector is
shown in Figure 1-3.
Step 2: Align the connectors . Align the Ethernet connector on the LAN cable with the
Ethernet connector on the ITDB-100L. See Figure 3-8.
Figure 3-8: Ethernet Connection
Step 3: Insert the LAN cable Ethernet connector . Once aligned, gently insert the LAN
cable Ethernet connector into the Ethernet connector on the ITDB-100L.
Step 4: Connect the other end of the Ethernet cable to the Ethernet connector of a
computer/network hub.