INTELLINET NETWORK 524681 User Manual - Manual (Page 94)

87
Remote IP Specify the remote (destination) IP address
Address: (e): that will be affected by this rule. Input the
starting IP address in the left field and input the
end IP address in the right field to define a
range of IP addresses, or just input the IP
address in the left field to define a single IP
address.
Remote Port
Input the range of remote (destination) port
Range (f): number that will be affected by this rule. If you
want to apply this rule on ports 80 to 90, input
“80-90”; if you want to apply this rule on a single
port, just input the port number, such as “80.”
If
the remote (destination) IP address and/or port
number is universal, just leave it blank.
Traffic Type (g): Select the traffic type of this rule. Options are
“None,” “SMTP,” “HTTP,” “POP3” and “FTP.”
You can select a specific traffic type for this rule:
If you want to make this rule an IP address-
based rule (apply the limitation on all traffics
from/to the specified IP address/port number),
select “None.”
Protocol (h):
Select the protocol type of this rule. Options are
“TCP” and “UDP.” If you don’t know what
protocol your application uses, try “TCP” first
and switch to “UDP” if this rule doesn’t seem to
work.
After you finish the settings, click “Save” (i). You’ll be brought back
to the previous menu, and the rule you just set will appear in the
current QoS table; if you did anything wrong, you’ll get an error
message when you click “Save.” Correct your entry as instructed by
the error message.
If you want to erase all the values you just entered, click “Reset.”