INTELLINET NETWORK 524681 User Manual User Manual

Page 86

Enable Wireless To enforce MAC address filtering, check
Access Control (4): “Enable Wireless Access Control.” When this

item is unchecked, the router will not enforce
MAC address filtering of wireless clients.

MAC Address (5): Input the MAC address of your wireless devices

here. Dashes ( - ) and colons ( : ) are not
required; i.e., if the MAC address label of your
wireless device is “aa-bb-cc-dd-ee-ff” or
“aa:bb:cc:dd:ee:ff.” just input “aabbccddeeff.”

Comment (6):

You can input any text here as a comment about
this MAC address, like “Room 2A Computer.”
Enter up to 16 alphanumerical characters here.
This is optional and you can leave it blank.

Add (7):

Click “Add” to add the MAC address and
associated comments to the MAC address
filtering table.

Clear (8):

Click “Clear” to remove the value you entered in
“MAC Address” and “Comment” fields.

After you finish the settings, click “Apply” (9) and the following
message will be displayed on your Web browser:

Click “Continue” to go back and continue with the router setup
procedure, or click “Apply” to reboot the router so the settings will
take effect. (Wait for about 30 seconds while the router reboots.)

If you want to reset all settings on this page back to previously
saved values, click “Cancel.”