INTELLINET NETWORK 524681 User Manual User Manual

Page 31

Text mode
Original mode

3. Basic Settings

Below are descriptions of each option:

Wireless Module (1): Click “Enable” to start using the wireless

function of this router, or select “Disable” to
close the wireless interface of this router.

Band (2): Select a band type from the drop-down list. It

allows you to set the router at 802.11b or
802.11g or 802.11n mode. You also can select
B+G or B+G+N mode to allow the router to
select an 802.11b, 802.11g or 802.11n
connection automatically.

SSID (3):

This is the name of the wireless router. You can
enter any alphanumerical characters here

NOTE: Some service providers use DHCP (Dynamic Host
Configuration Protocol) to assign an IP address to you. In this case,
you can choose Cable Modem as the Internet connection type even
you’re using another connection type, like xDSL. Also, some cable
modems use PPPoE, so you can choose PPPoE xDSL for such a
connection even if you’re using a cable modem.

2
3