INTELLINET NETWORK 524681 User Manual - Manual (Page 103)

96
Click “Continue” to go back and continue with the router setup
procedure, or click “Apply” to reboot the router so the settings will
take effect. (Wait for about 30 seconds while the router reboots.)
If you want to reset all settings on this page back to previously
saved values, click “Cancel.”
3-2-5 UPnP Settings
This function enables network auto-configuration for peer-to-peer
communications. With this function, network devices will be able to
communicate with other devices directly and learn about them.
Many network device and applications rely on the UPnP function
nowadays.
Click “NAT” on the left side of the Web management interface, then
click “UPnP.” The following message will be displayed on your Web
browser:
There is only one option on this page: Select “Enable” or “Disable”
to enable or disable the UPnP function, then click “Apply.” The
following message will be displayed on your Web browser: