Lucent Technologies 6000 - Manual (Page 333)

Configuring X.25
Always On/Dynamic ISDN (AO/DI)
MAX 6000/3000 Network Configuration Guide 6-47
#
# For a client with a fixed IP address, the Framed-Address and the
# Framed-Netmask attributes must be set for the client’s IP address.
#
Framed-Address=13.13.1.201,
Framed-Netmask=255.255.255.0,
#
# If the unit must assign an IP address, replace the attributes that
# set the local and/or remote IP address with the Ascend-Assign-IP-Pool
# attribute. Note that if Ascend-Assign-IP-Pool is used, there must be
# an Ascend-IP-Pool-Definition attribute defining the IP pool you are
# using.
#
Ascend-Route-IP=Route-IP-Yes,
Ascend-Metric=2,
#
# Although this is a dial-in profile, the Ascend-Send-Auth and
# Ascend-Send-Passwd/Ascend-Send-Secret are also needed in case the
# unit needs to initiate a B-channel call to add bandwidth.
#
# If the Answer profile specifies PAP authentication,
# replace:
# Ascend-Send-Auth=Send-Auth-CHAP,
# Ascend-Send-Secret="aodi1",
# with:
# Ascend-Send-Auth=Send-Auth-PAP,
# Ascend-Send-Passwd="aodi1",
#
Ascend-Send-Auth=Send-Auth-CHAP,
Ascend-Send-Secret="aodi1",
#
# To allow bandwidth management, Ascend-BACP-Enable must be set to
# "BACP-Yes",
#
Ascend-BACP-Enable=BACP-Yes,
Ascend-Base-Channel-Count=1,
Ascend-Minimum-Channels=1,
Ascend-Maximum-Channels=3,
Ascend-Inc-Channel-Count=1,
Ascend-Dec-Channel-Count=1,
Ascend-Target-Util=50
Changes to show users command
The show users command now shows active AO/DI calls. The follow example shows an
inbound AO/DI call with the X.25 channel and two B channels up. The three channels and
calls are identified as answered by the same dial-in profile. The profile is specified by the
profile name (as shown by the User Name field), the caller’s IP address (as shown by the Host
Address field), or the mpID.
ascend% sh users
I Session Line: Slot: Tx Rx Service Host User