Lucent Technologies 6000 - Manual (Page 234)

4-102 MAX 6000/3000 Network Configuration Guide
Configuring Individual WAN Connections
Configuring POTS capability on the MAX 6000 and MAX 3000
The alternative profile appears.
2 Press Ctrl-D to access the DO menu.
The DO menu appears.
3 Select L (Load).
Note: The Load option does not appear when you are in the active profile.
4 The alternative profile becomes the active profile.
Call Routes profile
You must configure a Call Routes profile to specify how the MAX unit handles the call. In the
System profiles, you can configure up to 64 Call Routes profiles. The MAX uses the profiles to
control the routing of POTS calls. When a call matches Phone Number, Src Slot, Src Port and
Call Rte Type, the unit routes the call as specified by the other parameters in that profile.
In each System > Call Routes profile, set the following parameters to identify and activate the
profile:
Viewing Call Routes with the DO command
The View Call Routes DO command (Ctrl-D, K) displays several fields of currently active call
routes (in the order in which they would be searched). This display also shows the specific call
route profile (in System > Call Routes) that was used to generate the call route.
Parameter Specifies
Name Name of the profile.
Active Profile is active if this parameter is set to Yes.
Every call will be matched against the following parameters:
Phone
Number Destination telephone number of the call.
Src Slot Call’s source slot number.
Src Port Call’s source port number.
Call Rte Type Call’s type of call to which this call route applies.
Set the following parameters to specify how the MAX routes calls that match the profile:
Dst Chan Grp Call’s destination MAXDAX channel group.
Dst Trnk Grp Call’s destination trunk group.
Dst Slot Call’s destination slot.
Dst Port Call’s destination port.
Dial Plan Number that identifies the Dial Plan profile to apply to the call.
Rewrt Pattn Telephone number that the unit compares to a number entered by a POTS
user.
Rewrt Replce Telephone number that replaces the number entered by a POTS user.