Lucent Technologies 6000 - Manual (Page 332)

6-46 MAX 6000/3000 Network Configuration Guide
Configuring X.25
Always On/Dynamic ISDN (AO/DI)
Ascend-Modem-SlotNo=9
Framed-Protocol=MP
Framed-Address=1.2.3.4
RADIUS dial-in AO/DI profile for PAP/CHAP with a fixed IP address
You can now configure an AO/DI DNIS-service profile. The first-tier dial-in setup uses the
new AO/DI value for Ascend-Call-Type. For example:
#
# AO/DI service-based DNIS profile. (12345 is the X.25 called address.)
#
12345 Password="Ascend-DNIS", User-Service=Dialout-Framed-User
#
# The Ascend-Call-Type attribute must be set to "AO/DI" to indicate the
# AO/DI call type and to imply that the network interface for the PPP
# link is a nailed channel on the X.25 network interface.
#
Ascend-Call-Type=AO/DI,
#
# To set the stage for the second-tier dial-in profile,
# Ascend-Require-Auth must be set to "Require-Auth".
#
Ascend-Require-Auth=Require-Auth
#
# By default, the system uses the same X.25 profile as the incoming
# X.25 SVC call.
#
For the second-tier dial-in, you can set up an individual user profile with PAP or CHAP
authentication and a fixed IP address. For example:
#
# AO/DI user/client profile for CHAP authentication.
#
aodi1 Password="aodi1"
User-Name="aodi1",
#
# The Framed-Protocol must be set to MP.
#
Framed-Protocol=MP,
#
# The Ascend-Call-Type attribute must be set to "AO/DI" to indicate the
# AO/DI call type and imply that the network interface for the first MP
# link is a nailed channel on the X.25 network interface.
#
Ascend-Call-Type= AO/DI,
#
# Ascend-Dial-Number specifies the B-channel number to dial when the
# unit needs to initiate the call for adding bandwidth.
#
Ascend-Dial-Number=953762,