Lucent Technologies 6000 - Manual (Page 327)

Configuring X.25
Always On/Dynamic ISDN (AO/DI)
MAX 6000/3000 Network Configuration Guide 6-41
Displaying packet processing for a specific session
The Ethernet > WAN Stat window displays the name, number of received packets, number of
transmitted packets, and number of CRC errors of each online connection. For example, when
the MAX establishes an AO/DI connection, the following window appears:
|-------------------|
|AODI1 |
|Rx Pkt: 7085 |
|Tx Pkt: 603 |
| CRC: 0 |
|-------------------|
RADIUS support for Always On/Dynamic ISDN (AO/DI)
The MAX supports RADIUS accounting records for each active RADIUS dial-in AO/DI call
and provides RADIUS dial-in AO/DI profile support for PAP/CHAP authentication with a
fixed IP address or dynamic IP address assignment. However, the MAX does not ask for name
and PAP/CHAP password information when the X.25 Switched Virtual Circuit (SVC) is an
outgoing call. Some changes to the show users command apply as well.
Accounting records for each active AO/DI call
This section provides information about the contents of the Start and Stop records for an active
AO/DI call.
Start records
Because AO/DI is largely based on MP, the RADIUS accounting records for AO/DI look very
much like the accounting records for MP calls. The following example shows the details of a
RADIUS accounting Start record for an X.25 SVC session of an active AO/DI call:
Sun Jan 17 12:40:24 1999
User-Name="aodi1"
NAS-Identifier=12.12.6.212
NAS-Port=12508
NAS-Port-Type=Sync
Acct-Status-Type=Start
Acct-Delay-Time=0
Acct-Session-Id="285427838"
Acct-Authentic=RADIUS
Ascend-Multilink-ID=2
Ascend-Num-In-Multilink=1
Ascend-Modem-PortNo=3
Ascend-Modem-SlotNo=9
Framed-Protocol=MP
Framed-Address=13.13.1.201