Spectra Logic Spectra 12000 - Manual (Page 96)

96 Spectra 12000 User Guide
Installing TAOS ITP on Solaris
TAOS ITP is supported on Solaris versions 2.6 and later.
Caution: TAOS ITP must be used with a software package
that provides a Shared Storage Option (SSO) type
arbitration between machines that backup to the library. If
you do not have an SSO type option, the only valid
configuration is one computer per library. Without an SSO
type option, data loss is likely.
To install TAOS ITP on a Solaris system:
1. Navigate to the solaris directory under the taos* directory on the
CD-ROM disk.
2. Run the script install.sh .
3. Choose a directory to which the script will untar the package. This
can be a temporary directory. The install script will start
automatically.
4. When prompted Select package(s) you wish to process
(or ’all’ to process all packages) , tap Enter to install
TAOS ITP.
5. When asked if you want to continue with the installation of TAOS
ITP, enter
y .
6. When prompted again Select package(s) you wish to
process (or ’all’ to process all packages) , enter q .
7. Enter y to install and configure TAOS enabled devices.
TAOSdiscover searches for TAOS enabled devices and lists each device’s
target components.
8. Enter the number of a listed device you want to install drivers for.
9. Enter the target number for all targets of this device you will want
access to, or just tap Enter to select all target numbers.
10. Repeat Step 8 and Step 9 for each device you want installed.
To remove a device, re-enter it. You will then be asked if you want to
remove the device.