Spectra Logic Spectra 12000 - Manual (Page 176)

176 Spectra 12000 User Guide
Fibre Configuration
The Fibre Configuration menu allows you to configure the fibre port. To
launch the Fibre Port Configuration menu, select
2 .
To configure the fibre port, use the following commands:
[1] Loop ID Type: Toggles between hard and soft loop ID. If a hard loop ID is
selected you will be asked to provide a loop ID number. No loop ID
number is needed for a soft loop ID.
[2] Loop ID: Only necessary with a hard loop ID.
[3] Connection: Prompts for selection of Loop, Fabric or Auto for fibre
connection mode.
[3] Initiator: Either enabled or disabled. This should be disabled unless
your environment can handle multiple fibre initiators on the same loop.
[?] Help: Displays help for this menu.
[Esc] Return to Main Menu: Returns you to the main menu.
Figure 11-14 The Fibre Configuration menu.