Icom IC-7700 - Manual (Page 208)

16-7
D D IP address setting
IMPORTANT!: A fixed (static) IP address is used for
the IC-7700.
When you connect the IC-7700 to a LAN, ask the
network manager about a usable/assignable IP
address and the subnet mask in advance.
NEVER use an IP address that has already been
used with another device in the network. If the IP
address is duplicated, the network will crash.
q Push several times to close a multi-func-
tion screen, if necessary.
w Push [F-7•SET] to select set mode menu screen.
e Push [F-5•OTHERS] to select Others set mode.
r Push [F-1• Y ]/[F-2• Z ] several times to select “IP Ad-
dress” item.
t Push [F-3• Ω ≈ ] to select the desired part then ro-
tate the main dial to set the desired or specified IP
address.
• “192.168.0.1” is the default setting.
y Push [F-2• Z ] to select “Subnet Mask” item.
u Rotate the main dial to set the desired or specified
subnet mask.
• “255.255.255.0” is the default setting.
i Push to turn the transceiver power OFF,
then ON to enable the IP address and subnet mask
settings.
POWER
EXIT/SET
When updating the firmware from the USB-Memory,
the following settings are not necessary.
F-2 F-3 F-1
Ω ≈
F-5
OTHERS EXIT/SET
F-7
SET ∫ √
16
UPDATING THE FIRMWARE