Icom IC-7700 - Manual (Page 163)

12-10
12
SET MODE
■
Display set mode (continued)
Selects the desired S/RF meter type during normal
screen indication from Standard, Edgewise and Bar.
(default: Standard)
Meter Type (Normal Screen) Standard
Selects the desired S/RF meter type during wide
screen or mini scope indication from Edgewise and
Bar. (default: Bar)
Meter Type (Wide Screen) Bar
Turns the meter peak hold function ON and OFF.
(default: ON)
This function is used for the bar meter only.
Meter Peak Hold (Bar) ON
Selects the pop-up display for the APF filter width
from ON and OFF.
(default: ON)
APF–Width Popup (APF OFF ON) ON
Enables the pop-up indication capability when the
notch filter width is changed from ON to OFF.
(default: ON)
MN–Q Popup (MN OFF ON) ON
Sets the memory name indication, during memory
mode operation, ON and OFF. (default: ON) • ON : The programmed memory name is displayed
above the frequency indication.
• OFF : No memory name is displayed even a mem-
ory name is programmed.
Memory Name ON
Set meter needle response from SLOW, MID and
FAST. (default: MID) This setting is effective for the standard and edge-
wise meter type selections only.
Meter Response MID