Icom IC-7700 - Manual (Page 140)

9-6
■
Memory scan operation
q Push several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
e Push [F-5•SCAN] to select the scan screen.
r Set [SQL] open or closed.
• See page 9-2 for squelch condition.
t Push [F-1•MEMO] to start the memory scan.
• “ ” and decimal points blink while scan-
ning.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u To cancel the scan, push [F-1•MEMO].
• Rotating the main dial also cancels the scan.
2 or more memory channels must be programmed
for memory scan to start.
■
Select memory scan operation
q Push several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
e Push [F-5•SCAN] to select the scan screen.
r Set [SQL] open or closed.
• See page 9-2 for squelch condition.
t Push [F-5•SEL No.] several times to select the se-
lect scan number from
★
1,
★
2,
★
3 and
★
1/
★
2/
★
3.
y Push [F-1•MEMO] to start the memory scan.
• “ ” and decimal points blink while scan-
ning.
u Push [F-3•SELECT] to start select memory scan;
push [F-3•SELECT] again to return to memory scan,
if desired.
• “ ” blinks instead of
“ ” during select memory scan.
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
o To cancel the scan, push [F-1•MEMO].
• Rotating the main dial also cancels the scan.
2 or more memory channels must be designated as
select memory channels, as well as the same select
scan channel number, for select memory scan to
start.
MEMORY SCAN
SELECT MEMORY SCAN
MEMORY SCAN
EXIT/SET
MEMORY SCAN
EXIT/SET
[SQL] Main dial EXIT/SET
F-1
MEMO
F-3
SELECT
F-5
SEL No.
[SQL] Main dial EXIT/SET
F-1
MEMO
9
SCANS