Tx function, Monitor function – Icom IC-7700 User Manual
Page 112

6-4
■ ∂
∂
TX function
The
∂
TX function shifts the transmit frequency up to
±9.999 kHz in 1 Hz steps (10 Hz steps when cancelling
the 1 Hz step readout) without moving the receive fre-
quency.
q
Push .
• “
” appears.
w
Rotate [RIT/
∂
TX].
e
To reset the
∂
TX frequency, push and hold
for 1 sec.
• Push
momentarily to reset the
∂
TX frequency
when the quick RIT/
∂
TX clear function is ON. (p. 12-15)
r
To cancel the
∂
TX function, push
again.
• “
” disappears.
D
D ∂
∂
TX monitor function
When the
∂
TX function is ON, pushing and holding
[XFC] allows you to monitor the operating frequency
directly (
∂
TX is temporarily cancelled).
✔
For your convenience— Calculate function
The shift frequency of the
∂
TX function can be
added/subtracted to the displayed frequency.
➥
While displaying the
∂
TX shift frequency, push and
hold
for 1 sec.
■
Monitor function
The monitor function allows you to monitor your trans-
mit IF signals in any mode. Use this to check voice
characteristics while adjusting SSB transmit parame-
ter (p. 12-5). The CW sidetone functions regardless of
the switch
setting.
q
Push
to switch the monitor function ON
and OFF.
• [MONITOR] indicator above this switch lights green.
w
Rotate [MONI GAIN] for the clearest audio output
while pushing [PTT] and speaking into the micro-
phone.
NOTE: When using the VOX voice delay, turn the
monitor function OFF; or transmitted audio will be
echoed.
MONITOR
MONITOR
∂
TX
∂
TX
∂
TX
CLEAR
CLEAR
∂
TX
∂
TX
[RIT/
∂
TX]
∂
TX
CLEAR
XFC
[MONI GAIN]
MONITOR
6
FUNCTIONS FOR TRANSMIT