IBM AA-RWF3A-TE - Manual (Page 58)

Create an Ethernet connection
To create an Ethernet connection:
1. Connect an Ethernet cable to the Ethernet port and to the workstation, or to an
Ethernet network containing the workstation, as shown in Figure 22 on page 58.
NOTE:
Figure 22
shows the 4/16 SAN Switch; however, this procedure is similar
for all SAN Switches.
0016b
! IO IOI
ATT EN TIO N:
Max imum s
crew le ngth for rack
mou nting to b e 5mm
or 1 3/6 4 in .
Figure 22 Connecting the Ethernet cable
Once the Ethernet cable is connected, access the switch remotely via the CLI or the
integrated Advanced Web Tools GUI software.
2. Log in to the switch via Telnet, using the admin account.
Modify the FC domain ID (optional)
You can modify the FC domain ID. The default FC domain ID is 1. If the switch is not
powered on until after it is connected to the fabric, and the default FC domain ID is
already in use, the domain ID for the new switch is automatically reset to a unique value.
If the switch is connected to the fabric after it has been powered on, and the default
domain ID is already in use, the fabric segments.
To determine the domain IDs that are currently in use, issue the fabricshow command.
The number of domains is determined by your domain fabric licensing.
To modify the domain ID:
1. Issue the switchdisable command to disable the switch.
2. Issue the configure command. The prompts display sequentially: enter a new
value or press Enter to accept each default value.
58 Installing and configuring SAN Switches