Intel STL2 - Manual (Page 75)

STL2 Server Board TPS Jumpers and Connectors
Revision 1.0 5-67
Table 5-4. Jumper Block 1L4 Settings
Jumper Pin
Numbers
Function Jumper Position Function
1 – 2 FRB Open, Enabled Enables FRB
Closed, Disabled Disables FRB
3 – 4 Front Cover Chassis Intrusion
Sensor Open, Enabled Enables Chassis Intrusion
sensing. This jumper may be
under as a chassis intrusion
switch connector.
5 – 6 Side Cover Chassis Intrusion
Sensor Closed, Disabled Disables Chassis Intrusion
sensing
Open, Enabled Enables Chassis Intrusion
sensing
7 – 8 No Function Open, Not Used No Function
9 – 10 Reserved Open, Not Used No Function
11 – 12 No Function Open, Not Used No Function
9 – 11 Spare Closed, Spare Provides a spare jumper
5.1.3 Setting Configuration Jumper Block 6A
Setting the jumpers on system board jumper block 6A enables the user to configure the front
cover chassis intrusion sensing. Jumper 6A pins 1-2 may also be used as a chassis intrusion
switch connector. The following table lists the factory default settings for jumper block 6A.
Table 5-5. Jumper Block 6A Settings
Jumper Pin
Numbers
Function Jumper Position Function
1 – 2 Front Cover Chassis
Intrusion Sensor Open, Enabled Enables Chassis Intrusion sensing. This
jumper may be under as a chassis intrusion
switch connector.
Closed, Disabled Disables Chassis Intrusion sensing
3 – 4 Reserved Open, Enabled Enables Chassis Intrusion sensing
5 – 6 No Function Closed, Disabled Disables Chassis Intrusion sensing
7 – 8 Reserved Open, Not Used No Function
5.2 Connectors
This section provides pin information about the connectors on the STL2 server board.