Intel STL2 - Manual (Page 34)

Server Management STL2 Server Board TPS
3-26
Sensor Type Sensor Type
Code Sensor-Specific
Offset Event Remarks
Platform Security
Violation Attempt 06h 00h Secured Mode Violation
Attempt Power/sleep switch has been
activated while in Secure Mode
03h Pre-boot Password Violation
(network boot Password) Bad Password at PXE Boot
Processor 07h 00h IERR CPU IERR has occurred
01h Thermal Trip CPU Thermal Trip has occurred
02h FRB1/BIST Failure BIST Error has occurred
04h FRB3/Processor
Startup/Initialization failure
(CPU didn’t start) FRB3 Timeout has been detected
08h Processor disabled A processor has been Disabled
Memory 0Ch 00h Correctable ECC ECC 1-bit error occurred
01h Uncorrectable ECC ECC 2-bit error occurred
POST Memory Resize 0Eh POST Memory Resize Displays the total amount of memory
after memory failure
POST Error 0Fh POST Error POST Error occurred
Event Logging
Disabled 10h 00h Correctable Memory Error
Logging Disabled Displays ECC single bit error
monitoring disabled
01h Event ‘Type’ Logging Disabled Monitoring of a certain event type
has been disabled
02h Log Area Reset/Cleared Displays the SEL area cleared.
03h All Event Logging Disabled Monitor for the entire BMC has been
disabled.
System Event 12h 00h System Reconfigured Setup change has occurred
01h OEM System Boot Event (Hard
Reset) Cold reset has been issued
Critical Interrupt 13h 00h Front Panel NMI Dump Switch Dump switch has been activated
02h I/O channel check NMI ISA I/O Check has occurred.
04h PCI SERR PCI SERR occurred
05h PCI PERR PCI PERR occurred
Button 14h 00h Power Button Power switch has been activated
01h Sleep Button Sleep switch has been activated
02h Reset Button Reset switch has been activated
Module / Board 15h CPU / Terminator Missing CPU / Terminator is not mounted
correctly
System Boot Initiated 1Dh 03h User requested PXE boot PXE (Network) Booted
04h Automatic boot to diagnostic When the maintenance Utility
Booted
Boot Error 1Eh 00h No bootable media Boot Media does not exist.
02h PXE Server not found PXE Server is not found
00h C: boot completed ESM Pro installed OS has been
booted
02h PXE boot completed PXE boot for the express server is
finished (not supported)
03h Diagnostic boot completed Maintenance Utility has been booted
(not supported)