Intel STL2 - Manual (Page 65)

STL2 Server Board TPS Basic Input Output System (BIOS)
Revision 1.0 4-57
Key Action
Arrows Up and down arrows move from one parameter to another within a screen.
ENTER Displays options for a configurable parameter. Selects an option.
ESC Moves back to previous screen or parameter or EXIT if at the Main menu.
F5 Switches between color and monochrome.
F6 Resets to host adapter defaults.
The following table shows the normal settings for the Adaptec SCSI Utility and provides a
place to record any changes made to these settings.
Table 4-27. Adaptec SCSI Utility Setup Configurations
Option Recommended Setting or
Display Only
User Setting
SCSI Bus Interface Definitions
Host Adapter SCSI ID 7
SCSI Parity Checking Enabled
Host Adapter SCSI Termination Enabled
Additional Options
Boot Device Options Press Enter for menu
Boot Channel A First
Boot SCSI ID 0
Boot LUN Number 0
SCSI Device Configuration Press Enter for menu
Sync Transfer Rate (MBps) 160
Initiate Wide Negotiation Yes
Enable Disconnection Yes
Send Start Unit Command Yes
Enable Write Back Cache No
BIOS Multiple LUN Support No
1
Include in BIOS Scan Yes
1
Advanced Configuration Options Press Enter for menu.
Plug-and-Play SCAM Support Disabled
Reset SCSI Bus at IC Initialization Enabled
Display Messages During BIOS Initialization Enabled
Extended BIOS Translation for DOS Drives >1 Gbyte Enabled
Verbose/Silent Mode Verbose
Host Adapter BIOS (Configuration Utility Reserves BIOS
Space) Enabled 1
Domain Validation Enabled
Support Removable Disks Under BIOS as Fixed Disks Disabled
1, 2
BIOS Support for Int13 Extensions Enabled
1
Notes:
1. No effect if BIOS is disabled.