Intel STL2 User Manual
Page 61
STL2 Server Board TPS
Basic Input Output System (BIOS)
Revision 1.0
4-53
Code
Error Message
Failure Description
0230:
System RAM Failed at offset
System RAM error
Offset address
0231:
Shadow RAM Failed at offset
Shadow RAM Failed
Offset address
0232:
Extend RAM Failed at address line
Extended RAM failed
Offset address
0233:
Memory type mixing detected
Memory type mixing detected
0234:
Single – bit ECC error
Memory 1 bit error detected
0235:
Multiple- bit ECC error
Memory multiple-bit error detected
0250:
System battery is dead – Replace and run SETUP
NVRAM battery dead
0251:
System CMOS checksum bad – Default configuration
used
CMOS checksum error
0252:
Password checksum bad - Passwords cleared
0260:
System timer error
System timer error
0270:
Real time clock error
RTC error
0271:
Check date and time setting
RTC time setting error
02B0:
Diskette drive A error
02B2:
Incorrect Drive A type – run SETUP
Incorrect Drive A type
02D0:
System cache error – Cache disabled
CPU cache error
0B00:
Rebooted during BIOS boot at Post Code
0B1B:
PCI System Error on Bus/Device/Function
PCI system error in Bus/device/Function
0B1C:
PCI Parity Error in Bus/Device/Function
PCI system error in Bus/device/Function
0B50:
CPU#1 with error taken offline
Failed CPU#1 because an error was detected
0B51:
CPU#2 with error taken offline
Failed CPU#2 because an error was detected
0B5F:
Forced to use CPU with error
An error detected in the entire CPU
0B60:
DIMM group #1 has been disabled
Memory error, memory group #1 failed
0B61:
DIMM group #2 has been disabled
Memory error, memory group #2 failed
0B62:
DIMM group #3 has been disabled
Memory error, memory group #3 failed
0B63:
DIMM group #4 has been disabled
Memory error, memory group #4 failed
0B6F:
DIMM group with error is enabled
An error detected in all the memory
0B70:
The error occurred during temperature sensor reading
Error while detecting a temperature failure.
0B71:
System temperature out of the range
Temperature error detected.
0B74:
The error occurred during voltage sensor reading
Error while detecting voltage
0B75:
System voltage out of the range
System voltage error
0B7C:
The error occurred during redundant power module
confirmation
The error occurred while retrieving the power
information
0B80:
BMC Memory Test Failed
BMC device (chip) failed
0B81:
BMC Firmware Code Area CRC check failed
0B82:
BMC core Hardware failure
0B83:
BMC IBF or OBF check failed
Access to BMC address failed
0B90:
BMC Platform Information Area corrupted.
BMC device(chip) failed
0B91:
BMC update firmware corrupted.
0B92:
Internal Use Area of BMC FRU corrupted.
SROM storing chassis information failed
(Available for use except for FRU command
and EMP function)