beautypg.com

Loading your paper – HP 8100 Series User Manual

Page 19

background image

Loading your paper

Paper loading tips:

You can print photos and documents on a wide variety of paper sizes, from 3 x 5
inches (76 x 127 mm) up to 8.5 x 14 inches (216 x 356 mm), as well as on 8.5
inch-wide (216 mm) banner paper.

Before loading paper, slide out the paper-width and length guides to make room
for the paper. After loading paper, adjust the guides to fit close to the edges of the
paper without bending the paper.

Load only one type and size of paper at a time. Do not mix paper types or sizes in
the Main input tray or the Photo tray.

After loading paper, extend the Out tray extension to hold your printed pages.
This prevents printed pages from dropping off of the Out tray.

Use the directions in the following table to load the most commonly used paper sizes
into the printer.

Paper type

How to load

Tray to load

Letter or A4
paper

Transparencies

8 x 10 inch (20
x 25 cm) photo
paper

1.

Raise the Out tray.

2.

Load plain paper, photo
paper, or transparencies
print-side down. Check
that the stack of paper is
no higher than the top of
the paper-length guide.

3.

Pull the Photo tray slider
towards you until it stops.
The Main light illuminates,
meaning that paper from
the Main tray will be used
for the next print job.

4.

Lower the Out tray.

Main tray

1 Out tray
2 Paper-width guide
3 Paper-length guide
4 Photo tray slider

4 x 6 inch (10 x
15 cm) photo
paper

Index cards

Hagaki cards

L-size cards

1.

Raise the Out tray.

2.

Load paper print-side
down. If you are using
tabbed paper, insert the
paper so the tab feeds in
last.

3.

Lower the Out tray.

4.

Push the Photo tray slider
away from you until it
stops. The Photo light
illuminates, meaning that
paper from the Photo tray
will be used for the next
print job.

Photo tray

1 Out tray
2 Paper-width guide
3 Paper-length guide

Chapter 2

16

HP Photosmart 8100 series