HP LC3040N - Manual (Page 50)

44 Troubleshooting
Problem Solutions
The picture is spotted. • There may be interference from automobiles,
trains, high-voltage lines, neon lights, or other
factors.
• There may be interference between the antenna
cable and power cable. Try positioning them
further apart.
There are stripes on the screen or colors
fade.
•
The unit may be receiving interference from other
devices. Transmission antennas of radio
broadcasting stations and transmission antennas of
amateur radios and cellular phones may also
cause interference.
•
Use the unit as far apart as possible from devices
that may cause possible interference.
Troubleshooting the remote control programming
Problem Solution
Red light does not blink when you press a key. Replace the batteries with two (2) new AA alkaline
batteries.
Red light blinks when you press a key, but home
entertainment component does not respond. Make sure the remote control is aimed at your home
entertainment component and is not farther than
15 feet away.
Remote control does not control home entertainment
components or commands are not working properly. Try all listed codes for the component brands being
set up. Make sure they can be operated with an
infrared remote control.
No volume on a 2nd TV. Follow instructions in “Changing Volume Lock.”
CH+, CH– , and CH.RTN do not work for your
RCA TV. Due to RCA design (1983–1987), only the original
remote control will operate these functions.
Changing channels does not work properly. If original remote control required pressing ENTER to
change channels, press ENTER on the Remote control
after entering the channel number.
Tried “Search Method” and still could not find a
working code. Try the “Search Method” again after clearing out the
component button as follows: Press and hold SETUP
until red light blinks twice, then release. Next enter
9 - 9 - 2. Then press and release the component
button to be cleared twice.