HP LC3040N - Manual (Page 26)

20 Using the TV
Remote control item Description
Indicator light The red light blinks once each time a button is
pushed. If the red light blinks two times when a
button is pushed, the remote control batteries are
low and need replacement.
Setup Use the SETUP button when programming the
remote control for component control.
PWR Press PWR once to turn on or off the selected
home entertainment component.
TV, CBL/SAT, DVD/VCR,
or HP.PC Press one of these buttons once to select a home
entertainment component to control. HP.PC selects
the HP Media Center PC (connected to the VGA
or DVI connector) and enables the HP MCPC
special buttons on the remote. To program the
remote control to operate a cable or satellite set-
top-box, or a DVD, or a VCR, see “Programming
the remote control for component control” on
page 22.
Keypad Use the keypad (0–9, +10) to directly select
channels.
Mute Press MUTE once to turn sound off or on.
VOL Use VOL+ (or VOL–) to raise (or lower) the sound
volume.
CH. RTN Press CH. RTN (channel return) once to recall the
last channel or to page back one screen in the
main menu.
HP.MC Press HP.MC to Start Media Center when using
the HP Media Center PC.
CH Use CH+ (or CH–) to select the next higher (or
lower) channel.
Guide Use GUIDE to display the program guide for a TV
set-top-box or for HP MCPC.
Exit/Back Use EXIT to exit out of the selected component’s
menu or guide. Use Back for the HP MCPC.
Up/down/left/right
buttons Use these cursor buttons to move the cursor in a
program guide or in menus.
Enter Press ENTER once after entering channel numbers
on some TV models. Use Enter as the OK button
for the HP MCPC.
Use Enter to bring up the OSD.