HP PROCURVE 530 - Manual (Page 67)

5-5
Troubleshooting
Diagnosing with the LEDs
T
rou
blesh
oot
ing
5 The
10/100Base-TX
network
connection is not
working
properly. Try the following procedures:
• Verify that both ends of the cabling, at the access point and the connected device, are
connected properly.
• Verify the connected device and access point are both powered on and operating
correctly.
• Verify duplex operation (see page 5-1).
• If these procedures don’t resolve the problem, try using a different cable.
6 The port may be
improperly
configured. VLAN configuration may affect the port operation. Use the access point’s console to see
how the port is configured for VLANs.
Make sure also, that the device at the other end of the connection is indicating a good
link to the access point. If it is not, the problem may be with the cabling between the
devices or the connectors on the cable.
Tip Problem Solution