HP PROCURVE 530 - Manual (Page 12)

1-4
Introducing the ProCurve Wireless Access Point 530
Top of the Access Point
In
trodu
cin
g
the
ProCurve
Wirel
e
ss
Access
P
oi
nt
530
LEDs
Table 1-1. Access Point LEDs
Access Point
LEDs State Meaning
Power
(green) On The access point is receiving power.
Off The access point is NOT receiving power.
LAN
(green) Off The RJ-45 port has no network cable connected, or is not receiving a link signal.
Blinking or
On The RJ-45 port has a link indication from a 10 Mbps or 100 Mbps device and is
transmitting or receiving traffic. The LED blinking rate is proportional to the traffic
rate. If there is no traffic, the blinking rate will be once every five seconds. As the
traffic rate increases, the blinking rate also increases until the LED is solid on, which
indicates there no available bandwidth on the port.
Radio 1 (11b/g)
Radio 2 (11a/b/g)
(green) Off The wireless interface is disabled, either through the access point console or the
Web browser interface.
Blinking or
On The wireless interface is enabled and transmitting or receiving traffic. The LED
blinking rate is proportional to the traffic rate. If there is no traffic, the blinking rate
will be once every five seconds. As the traffic rate increases, the blinking rate also
increases until the LED is solid on, which indicates there no available bandwidth
on the interface.