HP PROCURVE 530 - Manual (Page 47)

3-5
Getting Started With Access Point Configuration
Getti
ng St
art
ed With
Access
Poin
t Co
nfi
gurati
on
Select the two-character code for your country (refer to the Management and
Configuration Guide
for a full list of codes), then enter the country command
followed by your country code; for example, gb for Great Britain.
To Configure Radio Settings
The access point supports up to 16 Service Set IDentifier (SSID) interfaces
per physical radio interface. Most radio parameters apply globally to all
configured SSID interfaces. For each SSID interface, different security
settings, VLAN assignments, and other parameters can be applied.
Each SSID interface can be configured individually to enable or inhibit the
broadcast of the SSID in the radio’s beacon frames. SSID interfaces that are
not configured to broadcast the SSID are “hidden,” only being advertised in
probe responses.
When access point configuration parameters are changed, wireless stations
may be temporarily disconnected until the new configuration parameter is
enabled. This includes any changes to a WLAN or radio parameter.
N o t e The radios are disabled if the Country Code is not set. Once the Country Code
is set, the radios can be enabled.
ProCurve Access Point 530(config)#country gb
ProCurve Access Point 530(config)#write mem
ProCurve Access Point 530(config)#