High End Systems DL1 - Manual (Page 36)

3-4 Fixture Operation DL.1 User Manual
Menu Map
Use the following table to navigate the menu options on the DL.1 fixture.
Level 1 Level 2 Level 3 Option/Setting Description/Notes
enters /exits Menu System and moves up
levels moves between items on same
level. selects
scrolls between values
selects
DMX ADDRESS
MENU SET DMX START
CHANNEL:###
1-512
Selected value becomes the first DMX value
in the range for that mirror head on a DMX
512 link.
SET
PARAMETERS
MENU
FACTORY DEFAULT
SETTINGS:###
ON Reverts to DL.1 default settings
OFF Indicates a factory default has changed
PAN/TILT SWAP:
ENABLED Swaps the Pan and Tilt Motion
DISABLED Restores default Pan and Tilt Motion
PAN INVERT:
ENABLED Inverts Pan motor direction
DISABLED Restores default Pan motor direction
TILT INVERT:
ENABLED Inverts Tilt motor direction
DISABLED Restores default Tilt motor direction
DISPLAY LEVEL:
ON Turns display on
OFF Display fully dimmed when menu is locked
DATA LOSS TIMEOUT:
LONG Shutter closes when fixture shuts down
SHORT Shutter closes one second after data loss
PROJECTOR IN/SOURCE
RGBHV Selects RGBHV or VGA
SVIDEO Selects S-Video
NOT AVAILABLE Displayed when PROJ IN BY DMX is enabled
PROJCTR DEFAULT?
YES
Returns the projector to its factory default
settings.
NO Leaves the projector’s settings as they are.
RESET PROJ HRS
YES
Press for 5 seconds to reset
projector hours NO
PROJ LAMP ON?
XXX XXXXXXXXX
ON-TAKES 90 SEC Select ON and Lamp will strike after a
90-second delay. OFF
PROJ IN BY DMX?
ENABLED
Set projector input using channel 11 of the
DMX protocol.
DISABLED Set projector input using the menu system.
IRIS VERSION
#### V1.0
PRE 1.0
Identifies fixture iris version
POST 1.0
ZOOM OVERRIDE MENU
VALUE:###
0-255 Manually sets DMX zoom value
FOCUS OVERRIDE MENU
VALUE
###
0-255 Manually sets DMX focus value
PROJECTOR CONTROL ?
TO EXIT -> MENU
Select to hand off control to Projector. Navigation buttons now
control projector menu system. Use the MENU button used to
exit this option.
CAMERA OPTION
ENABLED
Digital Eye Technology installed and using
20-channel DMX protocol.
DISABLED
Disables Digital Eye Technology and reverts
to 12-channel reduced DMX protocol.
ALIGN PAN MOTORS
XXXXXX
YES Aligns motors (30 minutes to complete)
NO/ABORT Aborts align motors
NEW AIR FILTER?
XXX
YES
Selecting YES after new air filter installation
calibrates the fixture. NO
FIXTURE MODE
MENU
CROSSLOAD
FIRMWARE
NO Safe setting
YES
Uploads fixture software to all other DL-1
fixtures on the link