HP TOUCHSMART 9100 - Manual (Page 54)

Creating data backup discs
Use CD or DVD recording (or burning) software that is installed on your computer to create backup
discs of important information, including personal files, e-mail messages, and Web site bookmarks.
You can also move data to an external hard disk drive.
When writing data to a backup disc, use software that includes write verification functionality. This
feature compares the data on your hard disk drive with the data copied to the disc to ensure it is an
exact copy. Depending on your disc recording software, you may need to manually enable this
feature (refer to the software documentation).
If you encounter recording issues, try alternate media (different types or brands). Also, use the
Windows Explorer tool to view your files and verify content was copied over. To open Windows
Explorer, right-click the Start button, and then click Explore.
Clearing CMOS
When the BIOS has been incorrectly configured, it is sometimes necessary to clear all CMOS
settings.
To clear the CMOS, users need to perform the following steps:
CAUTION: Before attempting to remove or touch any parts from the motherboard, check that the
power cord is disconnected from the electrical outlet. Failing to do so can cause hardware damage
and even physical injury.
1. Shut down the operating system and turn off the computer and any external devices.
2. Disconnect the power cords of the computer and any external devices from the power outlet.
3. Disconnect any external devices that are connected to the computer.
4. Remove the chassis cover.
5. Locate the CMOS jumper header on the motherboard.
CAUTION: Removing the incorrect jumper can cause the system configuration to be changed
or even cause irreparable hardware damage.
6. Set the jumper to cover the middle and third pins for at least five seconds.
7. Set the jumper back in its original position.
8. Replace the hood cover.
9. Reconnect the external equipment.
10. Plug in the computer and turn on the power. Allow the operating system to start.
Clearing BIOS passwords
If a user has configured a power-on or setup password using the BIOS and then loses the password,
they cannot access the BIOS in order to change or clear the password.
In this event, to clear the power-on or setup passwords—or to disable the power-on or setup
password feature—users need to perform the following steps:
48 Chapter 6 Software Troubleshooting