Caution, Warning, Getting started – Hearth and Home Technologies Heat & Glo Twilight II-B User Manual

Page 6

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07

A. Design and Installation Considerations

Heat & Glo direct vent gas appliances are designed to
operate with all combustion air siphoned from outside of
the building and all exhaust gases expelled to the outside.
No additional outside air source is required.

The Twilight-II-B has been carefully engineered to pro-
vide a unique fi replace experience. Since it is different
than any other product on the market, care must be taken
when installing this appliance so that our customer does
not experience undesirable performance or conditions.

1. Install the appliance according to this Owner’s Guide

paying particular attention to fl ashing and sealing in-
structions.

2. In the cold northern climates pay attention to expo-

sures and prevailing wind conditions when locating the
appliance, the same as you would for locating exterior
windows and doors.

The Twilight-II-B has the thermal characteristics of a high
quality window system. Temperatures near the appliance will
be cooler than what is realized with a fully insulated wall.

Operation of the appliance will eliminate any cool drafts
and will provide the room with a comfortable ambiance.

C. Inspect Appliance and Components

When planning an appliance installation, it’s necessary to
determine the following information before installing:

• Where the appliance is to be installed. See Section 3.

• Gas supply piping. See Section 6.

• Electrical wiring. See Section 7.

• Framing and fi nishing details. See Sections 3 and 8.

• Whether optional accessories—devices such as a fan, wall

switch, or remote control—are desired. See Section 9.

B. Tools and Supplies Needed

Before beginning the installation be sure that the following
tools and building supplies are available.
Reciprocating saw

Framing material

Pliers

Hi temp caulking material

Hammer Gloves
Phillips screwdriver

Framing square

Flat blade screwdriver Electric drill and bits (1/4 in.)
Plumb line

Safety glasses

Manometer Voltmeter
Tape measure

Level

Non-corrosive leak check solution
1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
One 1/4 inch female connection (for optional fan)

• Carefully remove the appliance and components from

the packaging.

• Remove and keep outdoor fl ashing header from pallet

by removing two fasteners.

• The gas logs may be packaged separately and must be

fi eld installed.

• Report to your dealer any parts damaged in shipment,

particularly the condition of the glass.

• Read all of the instructions before starting the insta-

llation. Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.

Check building codes prior to installation.

• Installation MUST comply with local, regional, state and

national codes and regulations.

• Consult insurance carrier, local building, fi re offi cials or

authorities having jurisdiction about restrictions, installation
inspection, and permits.

CAUTION

Keep appliance dry.
• Mold or rust may cause odors.
• Water may damage controls.

Inspect appliance and components for damage.
Damaged parts may impair safe operation.

• Do NOT install damaged components.

• Do NOT install incomplete components.

• Do NOT install substitute components.

Report damaged parts to dealer.

Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:

• Installation and use of any damaged appliance or vent

system component.

• Modifi cation of the appliance or vent system.
• Installation other than as instructed by Hearth & Home

Technologies.

• Improper positioning of the gas logs.
• Installation and/or use of any component part not

approved by Hearth & Home Technologies.

Any such action may cause a fi re hazard.

WARNING

Getting Started