Hearth and Home Technologies Heat & Glo Twilight II-B - Manual (Page 24)

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07 24
9 9
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included with
accessories. See Service Parts List for appropriate acces-
sories. Refer to Section 13.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
D. Lava Rock and Ember Placement
Explosion Risk.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports.
• When placing Glowing Embers
®
onto the burner care
should be taken so that the ports are not covered. Place
the dime-size ember pieces just in front of the port trail,
but not on or in between the ports (see Figure 9.2). Fail-
ure to follow this procedure will likely cause lighting and
sooting problems.
Figure 9.2 Placement of Ember Materials
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
Placing Lava Rock
Place lava rock on refractory support pan. Cover entire
support pan surface (see Figure 9.1).
Figure 9.1 Placement of Lava Rock
WARNING
WARNING