Hearth and Home Technologies Heat & Glo Twilight II-B - Manual (Page 20)

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07 20
6 INCH
APPROX.
WIRE LEAD
1 MALE END
1 FEMALE END
TEMPERATURE
SENSOR SWITCH
WIRE LEAD
2 FEMALE ENDS JUNCTION
BOX
6 INCH
APPROX.
FAN
SPEED CONTROL
(RHEOSTAT)
FAN
PLUG AND WIRE
ASSEMBLY
OPTIONAL
WALL SWITCH
GREEN WIRE
INSIDE BOX
14/2WG
COPPER GROUND
ATTACHED TO GRN SCREW
WITH GRN WIRE
BLK
WHT
WHT BLK
HEAT SHIELD
E. Junction Box Installation
If the box is being wired from the OUTSIDE of the
appliance:
• Install the Romex ™ connector (not included with
appliance) in the side wrap.
• Loosen two screws on the Romex connector, feed
the necessary length of wire through the connector
and tighten the screws.
• Make all necessary wire connections.
If the box is being wired from the INSIDE of the
appliance:
• Remove the screw attaching the junction box to
the outer shell, rotate the junction box inward to
disengage it from the outer shell (see Figure 7.4).
• Pull the electrical wires from outside the appliance
through this opening into the valve compartment.
F. Wall Switch Installation for Fan (Optional)
Figure 7.4 Junction Box Detail
Figure 7.5 Junction Box Wired to Wall Switch
NOTE: Do NOT wire
110 VAC to wall switch.
• Loosen the two screws on the Romex connector, feed the
necessary length of wire through the connector and tighten the
screws.
• Make all necessary wire connections to the receptacle and
assemble the receptacle and cover to the junction box.
If the box is being wired to a wall
mounted switch for use with a fan
(See Figure 7.5):
• The power supply for the appliance
must be brought into a switch box.
• The power can then be supplied
from the switch box to the appli-
ance using a minimum of 14-3 with
ground wire.
• At the switch box connect the black
(hot) wire and red (switch leg) wire
to the wall switch as shown.
• At the appliance connect the black
(hot), white (neutral) and green
(ground) wires to the junction box
as shown.
• Add a 1/4 inch insulated female
connector to the red (switch leg)
wire, route it through the knockout
in the face of the junction box, and
connect to the top fan switch con-
nector (1/4 inch male) as shown.