Hearth and Home Technologies Heat & Glo Twilight II-B - Manual (Page 27)

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07 27
STEP 8.
LOG #7 (SRV703-703): Place log #7 on
the grate tine between log #2 and log #5. Rest one
end on the burner making sure not to cover any port
holes.
STEP 7.
LOG #6 (SRV2077-701): Set log #6 onto the grate bar as shown. Lay the “Y” end of log #6 onto log #1 resting
it into the small depression of log #1.
F. Glass Assembly
Removing Glass Assembly
Remove wing nuts and glass clips around glass door.
Remove glass door from the appliance.
Replacing Glass Assembly
Replace the glass door on the appliance.
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT clean glass with a razor blade.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
G. Grilles and Trim
Install optional marble and brass trim surround kits as de-
sired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that
the bottom grille can be lowered and the trim door re-
moved.
H. Shutter Settings
NG LP
Twilight-II-B 3/8 in. Full Open
1
2
4
5
6
3
1
2
4
5
6
3
7
WARNING