Re tu rn in g yo ur e -v ec tr a fo r, Replacing the hard disk, Step 5 step 6 step 7 – HP e-Vectra User Manual
Page 18
Returning Your e-Vectra for Repair
18
Re
tu
rn
in
g
Yo
ur
e
-V
ec
tr
a
fo
r
5 Lift the rear of the hard drive tray clear of the e-Vectra using the handle.
This is to gain access to the data and power connectors.
6 Remove the data and power connectors.
7 Using the handle, lift the hard drive tray out of the e-Vectra.
8 Place the hard disk drive tray in an antistatic bag and store it in a safe
place. Do not remove the hard disk drive from the drive tray.
Replacing the Hard Disk
1 Insert the protruding pins on the front of the hard disk drive tray in the
guiding grooves inside the hard disk drive compartment, then slide the
drive tray into position.
2 Lift the handle on the drive tray until the drives rear connectors are
accessible, then, reconnect the power and data cables.
3 Lower the rear of the hard disk drive tray into the drive compartment,
then click the handle back into position.
4 Ensure that all the drive cables are safely inside the compartment (not
trapped or snagging on anything).
5 Replace the compartment cover and slide it back into position.
6 Reconnect the cables and port control system (refer to “Securing Your
e-Vectra” on page 7).
Step 5
Step 6
Step 7