HP 1740 SHDSL - Manual (Page 62)

1740 SHDSL 2/4-Wire Router User’s Guide
CHAPTER 12 VLAN
To configure the VLAN function, click on VLAN in the Advanced menu bar. VLAN is disabled by factory
default. To enable it, select Enable and click on the Set button. Then you can proceed to create the
VLAN groups. The router supports four VLAN groups, 1 to 4. You can choose and join different Ethernet
ports to the PVC running in RFC 1483 bridged mode. Packets will be transmitted or received from these
ports to the appointed PVC. The packets of the VLAN groups are not routable. Packets that do not belong
to the VLAN group are routable.
Parameters and buttons
The PVC field displays the values of the PVCs that have been set up (refer to the WAN Setup section).
Click on the Set button to apply the settings, or click on the Clear button to delete a VLAN group.
Notes:
1. You must save the parameters and reboot your router before the VLAN will be active.
2. Each LAN can be assigned to only one group.
3. Each PVC can be assigned to only one group.
62 September 2004 1740-A2-GB20-10