HP 1740 SHDSL - Manual (Page 45)

1740 SHDSL 2/4-Wire Router User’s Guide
CHAPTER 7
7.1
Routing
This chapter describes how to set up the static routes and RIP. Click Routing Setup from the Basic menu
bar to configure the routing functions.
Static Route
The Static Route Configuration field allows you to add, modify, and delete a static route. Type the
Destination Network ID, subnet mask, and next hop IP and click a button below to perform the requested
function.
The router has no default static route. After an RFC 1483-routed VC is created, a static route as follows
will be created.
Network ID Subnet Mask Next Hop IP
0.0.0.0 0.0.0.0 10.0.0.2
Click Routing Setup on the Basic menu bar to access the Routing Setup window. It allows adding,
modifying, and deleting the static routes.
1740-A2-GB20-10 September 2004 45