HP ZX6000 - Manual (Page 18)

1–12 HP Integrity rx2600 server and HP workstation zx6000 Getting Started Guide
Setting Up and Using Your System
installing hardware components
If you purchased an accessory card, a graphics card, or other
hardware components that were not installed in your system at the
factory, you must install those components now.
Å WARNING: For most hardware installation procedures, you must power off
the system and unplug the power cord from the outlet.
NOTE: To maintain FCC/EMI (Electromagnetic Interference)
compliance, replace all covers and make sure all screws are properly
seated after you replace components.
1. If you have already connected and turned on the system, turn off
the system and disconnect all cables from the rear panel.
2. Remove the system access covers.
3. Install the new components:
❏ See the Installation Poster provided with your system for the
location of internal components.
❏ For detailed instructions on installing hardware components,
see the hp rx2600/zx6000 Operation and Maintenance Guide.
4. Replace the system access covers.
5. Connect the system.