Starting and stopping your system, Starting your system – HP ZX6000 User Manual
Page 16
1–10
HP Integrity rx2600 server and HP workstation zx6000 Getting Started Guide
Setting Up and Using Your System
starting and stopping your system
HP Integrity rx2600 servers and workstation zx6000s come in many
different configurations. Pay careful attention to the directions below
and choose the options that match the OS and packaging you
purchased.
starting your system
To start your system:
1. Turn on the monitor before you start your system.
2. Press the power button on the front panel. The system starts.
During system startup, the display may remain blank for up to
one minute. This is normal.
If the system has an MP card, the system light blinks.
If the system does not have an MP card, the following should
occur:
❏
Power LED turns on
❏
System LED blinks on and off
❏
On workstation zx6000s with no MP card installed,
diagnostic LEDs 1-4 create scrolling pattern
3. If you are prompted for a password, type it and press
Enter
.
The prompt displays only if you have set a password using the
Extensible Firmware Interface (EFI). (See “Management
Processor” on page 1-25.)