beautypg.com

Troubleshooting component video, Check component video – HP z558 User Manual

Page 27

background image

HP Digital Entertainment Center TV/Display Setup Guide

23

Troubleshooting Component Video

This section contains important information about correcting problems that you may encounter with your HP
Digital Entertainment Center Component Video Setup.

The component video connections are the green, blue, and red connectors, labeled Y, Pb, Pr, on
your HP Digital Entertainment Center back panel. These three connectors combine to form a
quality Video Out. (They do not transfer audio.) There are several types of Component Video Outs. The HP
Digital Entertainment Center supports YPbPr Component Video Out only.

Component Video Out requires specific configurations for certain display types and resolutions. You can adjust
the display for component video using:

The display wizard. See “TV/Display Setup Wizard” on page 5.

Or

See “HDTV Overscan Compensation” on page 12.

Check component video

To check component video before you begin:

1 Turn off the TV/Display.
2 Turn off the HP Digital Entertainment Center by pressing and holding the On/Standby power button for 4

seconds. The On/Standby button should be dark and not lit amber or blue.

3 Check the cables. Make sure that they are completely plugged in and that the green, blue, and red colors

match on both ends.

Green: Y, Blue: Pb, Red: Pr

4 Remove all other video out cables from the HP Digital Entertainment Center back panel, such as composite

video (yellow) and S-video cables.

5 Turn on the TV/Display.

6 Check the TV/Display input switch. For example “Component 1.”
7 Turn on the HP Digital Entertainment Center by pressing the On/Standby power button. Wait 1 to 2 minutes.

The video image should reappear.

8 Check your screen:

If you can see a distorted video image on your TV/Display while connected using component video, check
that the cable plugs are matched to the green, blue, and red connectors. See “Wrong Colors or Erratic
Video on Screen” on page 29.
Or

If you can see a video image on your TV/Display while connected using component video, use the
TV/Display Setup Wizard to optimize the component video image. See “TV/Display Setup Wizard” on
page 5. Follow the onscreen instructions. You should complete these procedures before troubleshooting.
Or

If you cannot see a video image on your TV/Display while connected using component video or the
problem is not resolved, use the following chart to correct the condition.