beautypg.com

Troubleshooting composite and s-video, No video after power on sequence, Keyboard does not work – HP z558 User Manual

Page 25

background image

HP Digital Entertainment Center TV/Display Setup Guide

21

No video after power on sequence

Problem: Some TV/Displays may display a blank screen because of the sequence in which you turn on and
turn off the HP Digital Entertainment Center and the TV/Display.

Solution: You must connect the Video Out cables to the HP Digital Entertainment Center and to the TV/Display,
before you apply power to the HP Digital Entertainment Center.

When you turn on the TV, make sure that it is set to the proper input setting. Turn off the HP Digital Entertainment
Center and then the TV before you change the cable connection to the TV. Afterwards, be sure to turn on the TV,
set it to the proper input setting, and then turn on the HP Digital Entertainment Center.

Keyboard does not work

Problem: The keyboard loses sync with the HP Digital Entertainment Center, or has never connected.

Solution: Do the following:

1 Check the keyboard operation. Press a key, the green LED should light on the upper right corner of the

keyboard.
If it does not light, check the batteries. Make sure the shipping tab is removed from the battery door on the
bottom of the keyboard. Retest the keyboard.

2 Turn off the HP Digital Entertainment Center by pressing and holding the On/Standby power button for 4

seconds. The On/Standby button should be dark and not lit amber or blue.

3 Turn on the HP Digital Entertainment Center by pressing the On/Standby power button. Wait 1 to 2 minutes.

The video image reappears.

4 Test the keyboard. Go to the next step if it still doesn’t work.
5 Briefly press the Keyboard Connect button on the HP Digital Entertainment Center front panel, behind the left

door. The button flashes, indicating the system is ready to connect (sync) with the keyboard.

6 Press the red Keyboard Connect button once on the bottom of the keyboard. The front panel Keyboard

Connect button flashes and stops, indicating a successful sync.

7 Test the keyboard. If it still doesn’t work:

Check the batteries for correct installation.

Remove interference sources that may interfere with transmission such as 49 MHz cordless phones, 49
MHz toy remote controls, or metal shelves or furniture.

Move the HP Digital Entertainment Center to another location and retest.

Troubleshooting Composite and S-video

This section contains important information about correcting problems that you may encounter with your HP
Digital Entertainment Center composite and S-video setup.

You can adjust the display for composite and S-video using:

The display wizard. See “TV/Display Setup Wizard” on page 5.

Or

The desktop. See “Desktop Video Adjustments” on page 14.