HP 4 FAMILY - Manual (Page 38)

HP LaserJet IIISi
Printer
Several new PCL features were added to the PCL 5
language with the release of the HP LaserJet IIISi printer.
These new features are summarized in Table 2-1 below.
HP LaserJet IIIP
Printer
Several new PCL features were added to the PCL 5
language with the release of the HP LaserJet IIIP printer.
These new features are summarized in Table 2-2. One new
feature listed here is adaptive compression (method 5) for
the Raster Compression Mode command. In addition to
compressing data for transmission, if certain rules are
followed (discussed below), the HP LaserJet IIIP printer
will store adaptive compressed data in compressed format
and only decompress it when required for printing. There
are certain requirements which must be met for this data to
be stored in compressed format. These requirements are
discussed following Table 2-2.
Feature Status Comments
Number of Copies Modified Greater range, 1 to 32,767.
Page Size Modified C5 Envelopes not supported.
Output Bin Selection Command New Allows programmatic selection of upper or lower
output paper bins.
End Raster Graphics Command New/Modified Modified version of the existing End Raster
Graphics command.
Job Separation New Command Causes the paper stacker to shift positions to
offset the output paper stack.
Fonts New Additions Four variations of Univers Condensed; ITC Zapf
Dingbats in five symbol sets.
Table 2-1. PCL Feature Additions for HP LaserJet IIISi Printer
2-2 Printer-Specific Differences