HP 4 FAMILY - Manual (Page 13)

PCL 5 Technical
Reference Manual
Corrections
This section describes updates to the PCL 5 Printer
Language Technical Reference Manual (5961-0509).
Because this manual will not be updated, any changes to it
are documented in this guide. Some errors have been
identified in the PCL 5 Printer Language Technical
Reference Manual since its printing. Those errors are
identified and corrections are provided on this page.
Chapter 4
PCL Job Control
Commands
Unit of Measure Command
In Figure 4-6 on page 4-18, the two escape sequences at the
top should read “(?&u100D) and (?&u200D)” instead of
“(?&u100B) and (?&u200B).”
Chapter 8
PCL Font Selection
Transparent Print Data Command
The last sentence in the note at the bottom of page 8-33
should read “Refer to the PCL 5 Comparison Guide,
Appendix A, for character codes for the various symbol
sets.” instead of “Refer to Appendix A for character codes for
the various symbol sets.”
Chapter 13
The PCL Print Model
User-Defined Pattern Command
In Figure 13-10 on page 13-19, byte zero should read
Format (20) instead of Format (0)
On page 13-21, Format (Byte 0) should read “0” for a 300
DPI user-defined pattern header and “20” for a
resolution-specified user-defined pattern header.
Feature Set 1-5