Preparing the rails for integrated shipping, Installing the ups – HP R5500 User Manual

Page 15

Text mode
Original mode

Installation 15

Tighten the hex nuts.

Preparing the rails for integrated shipping

If the unit is to be shipped in an HP 9000 or 10000 series rack:

Remove the hex nuts, flat washers, and lock washers from the mounting rail.

Install the rail reinforcement plates and tighten using the hex nuts with captive washers included in
the kit, instead of the nuts included with the rail.

Install the rear mounting brackets using hex nuts. Wait until the unit is installed and the brackets are
adjusted before tightening the nuts.

Installing the UPS

Before installing the UPS, review and observe all warnings in "Precautions (on page

)."